1.9 KiB

Raw Blame History

What?

ese-relay connects libese's functionality to a local abstract socket on an Android device. The primary purpose is to ease development and provision with test hardware without bringing up all the development tools needed.

ese-relay uses the same wire protocol as the Virtual Smart Card project by acting as the "viccd" service. This enables use of any tool that supports pcsc-lite without any additional development.

Wire protocol

The format is always Ln d0..dn Ln is a network byte order 16-bit unsigned integer length of the data. d0..dn are uint8_t bytes to tunneled directly to/from the card.

If Ln == 1, it indicates an out of band control message. Supported messages are 1:0 - 1:4:

0: Power off (ignored)
1: Power on (implemented with a reset)
3: Reset
4: ATR - returns a fake ATR

Prerequisites

pcscd is installed on your system.
Build and install https://frankmorgner.github.io/vsmartcard/virtualsmartcard
Configure /etc/reader.d/vpcd as below.
Build ese-relay configured for the hardware in use.

/etc/reader.conf.d/vpcd:

FRIENDLYNAME "Virtual PCD"
DEVICENAME   localhost:0x1000
LIBPATH      /usr/lib/pcsc/drivers/serial/libifdvpcd.so
CHANNELID    0x1000

This will cause pcscd to connect to localhost port 4096 on start as per the vsmartcard documentation.

Usage

In one terminal, run the service and forward the abstract UNIX socket to a local TCP socket:

$ adb shell ese-relay- $ adb forward tcp:4096 localabstract:ese-relay

In another terminal, restart pcscd configured with an appropriate reader:

$ /etc/init.d/pcscd restart # (Or whatever your init system requires.)

In yet another terminal, use your preferred* pcsc client:

$ java -jar gp.jar -info

https://github.com/martinpaljak/GlobalPlatformPro is used here.

1.9 KiB Raw Blame History